HOW TO OPERATE
1
Select ON or
OFF timer.
2
Set the
desired time.
3
Confi rm the
setting.
Timer
CANCEL
Cancel the
selected timer.
■ Operation Details
• Use the ON timer to turn on the air
conditioner at the desired time. This
will give you a cooling or warming
environment, e.g. when you return
from work or wake up.
• When the ON timer is set, operation
will start up to 35 minutes before the
actual set time.
• Use the OFF timer to stop the air
conditioner operation at the desired
time. This can save electricity while
you are going out or sleeping.
• The set timer will repeat daily once
it is set.
• If there is a power failure, you can
press SET button to restore the
previous setting once the power is
resumed.
• If the timer is cancelled, you can
restore the previous setting by
pressing SET button.
TIMER
●
Press CLOCK more than 10 seconds to change the time format from 24 hours to AM/PM format.
●
For your convenience, you could set the air conditioner to operate automatically by using both ON and OFF timer.
Hint
Troubleshooting
●
TIMER indicator always on.
➤ Timer is activated and the setting will repeat itself daily.
●
POWER indicator is blinking 35 minutes before ON
timer is activated.
➤ The unit is determining the operation mode by sensing the room
temperature. This happens when it has been set to AUTO operation
mode.
● Ensure the clock on the remote control has been set
correctly.
● You could use the ON and OFF timers at the same time.
● To cancel either the ON or OFF timer, press
or , then
press
.
CHECK
• When there is error, the unit stops
its operation and timer indicator
blinks.
1. Press for 5 seconds.
2. Browse for respective error code,
where “beep” sounds are heard.
3. Turn off the power supply and call
authorized distributor.
Note:
Press the ‘Reset’ button to quit
checking.
Unit might operate with limited function
depending on error found.
(Operation starts, 4 “beep” sound is
heard)
48
CS-E9DKDW CU-E9DKD / CS-E12DKDW CU-E12DKD
To Next Page
Loading...
