Oxygen indicator
Note: The illustrations in this manual are for explanation purposes only and may differ from the
actual unit. It is subjected to change without notice for future improvement.
PRODUCT OVERVIEW
Movable panel & Front panel
Indoor Unit
Outdoor Unit
OFF/ON
Temperature
setting
•
Make sure it is not obstructed.
• Maximum distance is 8m.
• Certain fluorescent lights may
interfere with signal transmission.
Consult your dealer
.
Remote Control Preparation
■ About
Remote Control Signal
• Timer operation will be based on
current time set.
•
The batteries can be used for
approximately 1 year.
• The batteries must be
disposed properly.
Remote Control
Auto OFF/ON Button
1. Pull out.
2.
Insert
batteries
(LR03).
3. Press CLOCK button.
4. Set
current
time.
5.
Press SET button to confirm.
Auto OFF/ON button
T
ransmitter
Oxygen Supply
(Service not
needed. Do not
open.)
Air filters
Airflow
Direction
Louver
Indicator
Receiver
Cooling,
Auto,
Heating, Dry
mode
Oxygen
operation
Ion operation
Fan speed/Airfl
ow
direction selection
T
imer setting
Quiet
operation
Check
Clock
operation
Powerful operation
Error reset
Sleep timer
LCD
display
Air inlet (rear)
Air outlet
Air inlet (side)
Troubleshooting
● Mist emerges from indoor unit.
➤ Condensation effect due to cooling process.
● Remote control/display does not work.
➤ Check whether batteries are correctly inserted or need replacement.
● The unit cannot operate.
➤ Check either circuit breaker is tripped, power plug is inserted correctly or
timer is used correctly
.
➤ Ensure “OFF” indicator does not shown on remote control.
● Outdoor unit emits water/steam.
➤ Condensation or evaporation happens at piping surface.
● If you wish to have the cool air blowing directly on you, set the airflow direction downward but not for an excessive length of time,
as it may harm your health.
● It is possible to dim the brightness of the indicators by pressing the button for 5 seconds. Repeat the process to return to
default brightness.
Hints
• To operate the unit if the remote
control is misplaced or
malfunctioning.
Action
Operation
mode
Press once.
Automatic
Operation
P
ress until “beep”
sound and release.
*Cooling
Operation
P
ress until “beep”
sound and release.
Press again until
“beep-beep” sound
and release.
*Heating
Operation
•
To OFF, press again the Auto OFF/
ON button.
*The usage of this button is not
recommended.
Do not
touch during
operation
Ionizer
Super alleru-buster
filter
To Next Page
Loading...
