ENGLISH
7
6
TO ENJOY CLEAN &
FRESH AIR
PATROL - To monitor air quality
• Detects air quality; e-ion operation activates when air
quality is at dirty level.
• Can be activated even when the unit is turned off.
• Patrol starts automatically with the unit switched on with
OFF/ON
.
7
TO FRESHEN AND PURIFY THE
AIR
• Generates negative ions to produce fresh air effect and
attract dust which will then be captured at the positively
charged e-ion fi lters.
• Can be activated even when the unit is turned off. In this
condition, fan speed and air swing can not be adjusted.
8
TO USE MAINTENANCE
HEATING
+8/10°C HEAT
• Maintain indoor temperature at 8/10°C. Fan switches to
high fan speed automatically.
• This operation overwrite the operation
mode and could be cancelled by
pressing
.
• Defrost operation at outdoor unit will
result in sudden cold air from indoor
unit.
Eliminate cold air with heat mode.
10˚C
8˚C
9
TO ENJOY QUIET OPERATION
• This operation reduces airfl ow noise.
10
TO REACH TEMPERATURE
QUICKLY
• This operation will stop automatically after 20 minutes.
11
Press and hold for 5 seconds to dim or restore the
unit’s indicator brightness.
12
Press and hold for approximately 10 seconds to
show temperature setting in °C or °F.
13
Press to restore the remote control’s default setting.
14
Not used in normal operations.
N
or
OFF
then
press
CANCEL
.
• When ON Timer is set, the unit may start earlier (up
to 35 minutes) before the actual set time in order to
achieve the desired temperature on time.
• Timer operation is based on the clock set in the
remote control and repeats daily once set. For clock
setting, please refer to Remote Control Preparation at
back cover.
• If timer is cancelled manually or due to power failure,
you can restore the previous setting (once power is
resumed) by pressing
SET
.