TO SET THE TIMER
• To turn ON or OFF the unit at a preset time.
TIMER
Select ON or
OFF timer.
Set the time. Confi rm.
• To cancel ON or OFF timer, press
or then
press .
• When ON Timer is set, the unit may start earlier (up
to 15 minutes) before the actual set time in order to
achieve the desired temperature on time.
• Timer operation is based on the clock set in the remote
control and repeats daily once set. For clock setting,
please refer to Remote Control Preparation at back
cover.
• If timer is cancelled manually or due to power failure,
you can restore the previous setting (once power is
resumed) by pressing
.
OPTIONAL SETTINGS
Patrol starts automatically with the unit
switched on with
.
Press and hold for 5 seconds, then release
to disable or restore this setting.
Press and hold for 5 seconds to dim or
restore the unit’s indicator brightness.
Press and hold for approximately 10
seconds to show temperature setting in
°C or °F.
Press and hold for approximately 5 seconds
to show 12-hour (am/pm) or 24-hour time
indication.
Press to restore the remote control’s default
setting.
,
Not used in normal operations.
Use curtains to screen off sunlight and outdoor heat to
reduce power consumption during cool mode.
• , , and can be activated
in all modes and can be cancelled by pressing the
respective button again.
•
only can be activated in COOL mode and can
be cancelled by pressing the button again.
•
and or , and can
not be selected at the same time.
•
and can be activated even when the unit
is turned off. In this condition, fan speed and air swing
can not be adjusted.
TO SELECT FAN SPEED (5 OPTIONS)
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
TO ADJUST AIRFLOW DIRECTION (5 OPTIONS)
• Keeps the room ventilated.
• If AUTO is set, the louvers swing left/right and
up/down automatically.
TO ENJOY CLEAN & FRESH
AIR
• Generates negative ions to produce fresh air effect
and attract dust which will then be captured at the
positively charged e-ion fi lters.
TO MONITOR AIR QUALITY
Indicator Air Quality
Blue Clean
Orange Moderate
Red Dirty
PATROL SENSOR
• Detects air quality; e-ion
operation activates when air
quality is at dirty level.
• Regardless of air quality, to maintain air freshness
e-ion activates automatically (PATROL SENSOR
indicator turn red) when:
- 2 minutes after the unit is on, or
- exceeds 4 hours at clean level.
• Fan speed is adjusted automatically.
TO IMPROVE HUMIDITY AND
MOISTURE LEVEL
MILD DRY COOLING
• This operation reduces air dryness and provides you
with a comfortable living environment.
•
When vertical airfl ow direction is set to AUTO, it stops
at lower position to avoid cold air contact. However, you
can adjust the louver direction manually
.
TO ENJOY QUIET
ENVIRONMENT
QUIET
• This operation reduces airfl ow noise.
TO ACHIEVE TEMPERATURE
QUICKLY
POWERFUL
• This operation will stop automatically after 4 hours.
To Next Page
Loading...
Need help?
General
