Remote control display
Press to restore the
remote control to
default setting.
Press and hold for
approximately
10 seconds to show
temperature setting in
°C or °F.
Not used in normal
operations.
To adjust horizontal airfl ow direction
• Manually adjustable.
Auto OFF/ON button
Use when remote control is
misplaced or a malfunction occurs.
Raise the front panel:
• To use in AUTO mode, press the
button once.
• To use in COOL mode, press and
hold the button until 1 beep is
heard, then release.
• Press the button again to turn off.
V7PWA, V9PWA,
V12PWA
MODE
To select operation mode
AUTO mode - For your convenience
• Unit selects the operation mode according to the
room temperature.
• Once AUTO mode is selected, the unit will
operate at the standard setting temperature.
Room
temperature
Operation
mode
Standard setting
temperature
23 °C & above COOL 25 °C
Below 23 °C DRY 22 °C
• Press for “HI” to +2 °C or for “LO” to
-2 °C to the standard setting temperature.
COOL mode - To enjoy cool air
• To reduce power consumption during COOL
mode, use curtains to screen off sunlight and
outdoor heat.
DRY mode - To dehumidify the environment
• Unit operates at low fan speed to give a gentle
cooling operation.
POWERFUL/
QUIET
To switch between
powerful & quiet
QUIETPOWERFUL NORMAL
POWERFUL: To reach temperature quickly
POWERFUL
• This operation stops automatically after 15
minutes.
QUIET: To enjoy quiet operation
QUIET
• This operation reduces airfl ow noise.
FAN SPEED
To select fan speed
(Remote control display)
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
To Next Page
Loading...
Need help?
General
