17
English
How to use
NANOE-G
To purify the air
NANOE-G
• nanoe-G starts automatically when the unit is turned
on with
OFF/ON
.
• Can be activated even when the unit is turned off.
In this condition, the unit will operate as a fan with
AUTO fan speed and louver swing.
To deactivate viruses/bacteria on the fi lter
NANOE-G
POWER
• Depending on the unit’s accumulated operation
time, nanoe-G in-fi lter deactivation may activate only
once a day after the unit turned off.
• To remove the moisture left in the internal parts, the
fan will operate for 30 minutes with louver opened
slightly. This process only applicable when the unit
is operated in COOL/DRY mode before turned off.
Then, nanoe-G deactivates viruses/bacteria on the
fi lter for 2 hours with fan stopped and louver closed.
• Do not turn off the power supply during this
operation. After power failure, this operation will not
resume.
• To disable this operation in the future, press and
hold
NANOE-G
until a short beep sound is heard. This
will not disable the nanoe-G to purify the air.
• To restore the nanoe-G in-fi lter deactivation, press
and hold
NANOE-G
until a long beep sound is heard.
AIR SWING
To adjust airfl ow direction
(Remote control display)
• Keeps the room ventilated.
• In COOL/DRY mode, if AUTO is set, the louver
swings left/right and up/down automatically.
• Do not adjust the louver by hand.
Note
POWERFUL/
QUIET
,
NANOE-G
• Can be activated in all modes and can be
cancelled by pressing the respective button
again.
POWERFUL/
QUIET
• Cannot be selected at the same time.
Operation conditions
Use this air conditioner under the following
temperature range.
DBT : Dry bulb temperature
WBT : Wet bulb temperature
Temperature (°C)
Indoor Outdoor
DBT WBT DBT WBT
COOL
Max. 32 23 43 26
Min. 16 11 16 11
To set the timer
To turn ON or OFF the unit at a preset time.
3
Confi rm
SET
TIMER
• To cancel ON or OFF timer, press
ON
or
OFF
then press
CANCEL
.
• When ON Timer is set, the unit may start
earlier (up to 15 minutes) before the actual
set time in order to achieve the desired
temperature on time.
• Timer operation is based on the clock set in
the remote control and repeats daily once
set. For clock setting, please refer to Quick
guide.
• If timer is cancelled manually or due to
power failure, you can restore the previous
setting (once power is resumed) by pressing
SET
.
To Next Page
Loading...
