36
nanoe™X fi lter deactivation
Depending on the unit’s accumulated operation time, the nanoe™X may be activated only
once a day after the unit is turned off standby mode. During the nanoe™X fi lter deactivation
operation, the fl ap will open slightly with low fan speed operation for 2.5 hours if the unit was
in COOL/DRY mode, and 2 hours if the unit was in nanoe™ TECHNOLOGY, before the unit
is turned off. This is to remove viruses/bacteria from the surroundings.
The fi lter deactivation operation is complete when the fan stops and the fl ap closes. Do not
turn off the power supply during this operation. After a power failure, this operation will not
resume.
Operating conditions
Use this air conditioner in the temperature range indicated in the table.
Temperature °C (°F)
Indoor Outdoor
DBT WBT DBT WBT
COOL
Max. 32 (89.6) 23 (73.4) 46 (114.8) 26 (78.8)
Min. 16 (60.8) 11 (51.8) 16 (60.8) 11 (51.8)
HEAT
*2
Heatpump model
Max. 30 (86.0) - 24 (75.2) 18 (64.4)
Min. 16 (60.8) - -5 (23.0) -6 (21.2)
DBT: Dry bulb temperature, WBT: Wet bulb temperature
To Learn More...
To Next Page
Loading...
