A-Board - Main chassis
1. Carefully pull out Y1, Y2, Y3 connectors from Y-board and plug
from second tuner of A-Board (models with PIP feature only).
2. Slide the chassis completely out of the guide rails.
3. Stand the receiver on its edge. The underside of the board is
completely accessible for component replacement.
Note:
Some tie-wraps that secure the wire dressings may need to be unfastened for chassis removal.
C-Board - CRT output
The board plugs onto the socket on the CRT neck. To release the Focus wire, use a dull object to
release the tab on the socket (near the wire opening) and carefully pull on the wire. To connect
the focus wire, press on the tab to lock it then insertthe wire in the opening and press on it until it
is fully inserted and locked in place. 36” models uses an additional screen wire that plugs into
the CRT socket. Use the same procedure of the focus wire. Carefully disconnect C1, C2, C11,C12,
C13 and C21 connectors.
Focus cable release
Y-Board - PIP processing (models with PIP feature only)
1. Slide the chassis completely out of the guide rails.
2. The underside of the board is completely accessible for
component replacement.
Speakers
Each speaker is secured to the cabinet with 4 screws.
17
To Next Page
Loading...
