(TP1 pin 2) to cold ground (TP1 pin 3).
The receiver enters the aging mode.
Yellow letters “CHK” appear in the upper left corner of the screen. / (The volume right/left and
channel up/down will adjust rapidly).
Note:
If service mode is accessed by this method be sure to reset the set
after service is performed.
12.1. Service adjustment default values for items
NAME DESCRIPTION REGISTER
VALUE
MTSIN MTS INPUT LEVEL 25
SEPAL MTS LOW LEVEL SEPARATION 08
SEPAH MTS HIGH LEVEL SEPARATION 21
CLOCK CLOCK 128
HHSTH HHS VOLTAGE LEVEL REFERENCE 9B
COLOR COLOR F0
TINT TINT 52
BRIGH SUB-BRIGHTNESS 74
CONT SUB-CONTRAST 58
B-Y_G MAGENTA TINT ADJ 80
CUT_G GREEN CUT-OFF CB
CUT_R RED CUT-OFF 93
CUT_B BLUE CUT-OFF BE
BRT BRIGHT 74
R-DR RED DRIVE 4E
B-DR BLUE DRIVE C2
PCONT PIP SUB-CONTRAST 70
H-POS HORIZONTAL POSITION 82
H-WID HORIZONTAL WIDTH 0F
PCC PINCUSHION CORRECTION 0A
TOPG TOP CORNER PINCUSHION C7
BTMG BOTTOM CORNER PINCUSHION C9
TRAP TRAPEZOID 7F
PCCHG PINCUSHION HIGH 14
PCCLG PINCUSHION LOW 06
PCCHS PINCUSHION HIGH 02
PCCLS PINCUSHION LOW 02
TOPSL TOP CORNER PINCUSHION SLICE LEVEL 87
BTMSL BOTTOM CORNER PINCUSHION SLICE LEVEL 34
VEAMP VERTICAL SIZE C8
V-C VERTICAL LINEARITY 4A
V-S VERTICAL SIZE CORRECTION 07
VPOS VERTICAL POSITION 7B
25
To Next Page
Loading...
