6. Turn screen clockwise slowly until color is slightly appeared.
7. Then adjust “CUT R” and “CUT B” until line becomes white.
8. Press RECALL button on the remote to restore the raster.
9. Adjust “R DR” and “B DR” so the white seems like white and black
like black.
10. Apply a normal signal and confirm that the image is normal and a
good gray scale.
11. If correction is needed perform minor touch-up method.
13.6. Deflection adjustments
To reset deflection adjustments
To reset deflection adjustments to factory adjusted default, enter to service mode (with red CHK
displayed), press POWER button on remote to display the service menu, then press and hold
RECALL button for at least three seconds, a reset message will appear in the image.
Use this feature when deflection adjustment gets off adjustment to the point that it cannot be
adjusted back easily.
13.6.1. H-Center adjustment
PREPARATION
1. Apply a crosshatch pattern.
2. Normalize the picture settings.
PROCEDURE
1. Apply a monoscope pattern to center the picture.
Horizontal Center Adjustment
31
To Next Page
Loading...
