Panasonic CU-A34BBP5 - Page 244

- Solder a sheathed PVC cord or cable (0.5 - 2.0 mm
2
) with specifications among those given below
to the remote control unit end of the accessory remote control cord (10m).
- PVC round cabtire cord
- PVC-insulated PVC sheathed cable for control use
- PVC-insulated PVC sheathed cable for control use
- 600 V PVC-insulated PVC sheathed round cable
- 600 V PVC-insulated PVC sheathed flat cable
- 600 V PVC-insulated PVC cabtire cable
NOTE
The maximum possible length for the remote control cord is 200 metres.
Remote control unit installation procedure
- Remove the remote control unit lower case. / (Insert a flat-tipped screwdriver or similar 2 to 3 mm
into one of / the gaps at the bottom of the case, and then twist the screwdriver / to open. [Refer to
the illustration at right.]) / Be careful not to damage the lower case.
- Secure the lower case to the wall or outlet box. / (Refer to the illustration at right for the embedded
and exposed / positions for the remote control cord.)
244