EasyManua.ls Logo

Panasonic CU-E12DKE - Timer Operation; Error Check

Panasonic CU-E12DKE
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
HOW TO OPERATE
1
Select ON or
Select ON or
OFF timer.
OFF timer.
2
Set the
desired time.
desired time.
3
Confi rm the
Confi rm the
setting.
setting.
Timer
CANCEL
Cancel the
selected timer.
selected timer.
■ Operation Details
•
Use the ON timer to turn on the air
conditioner at the desired time. This
will giv
e you a cooling or warming
environment, e.g. when you return
from work o
r wake up.
•
When the ON timer is set, operation
will start up to 35 minutes before the
actual set time.
•
Use the OFF timer
to stop the air
condition
er
operation at the desired
time. This can save electricity w
hile
you are going out or sleeping.
•
The set timer will repeat daily once
it is set.
•
If there is a power failure,
y
ou can
press SET button
to restore the
previous setting
once the power is
resumed.
•
If
the timer is cancelled
, you can
restore the previous setting by
pressing SET button.
TIMER
●
Press CLOCK more than 10 seconds to change the time format from 24 hours to AM/PM format.
●
For your convenience, you
could
set
the air conditioner to operate automatically by using both ON an
d OFF timer.
Hint
Troubleshooting
●
T
IMER
indicator always on
.
➤
T
imer
is activated and
imer is activated and imer
the se
tting
will repeat itself daily.
●
POWER indi
cator is blinking
3
5 minutes before ON
timer is activ
ated.
➤
The unit is determin
ing the operation mode by sensing the room
temperature
. This happens when it has
been set to AUTO
operation
mode.
●
Ensure the clock on the remote control has
been set
correctly.
●
You could use the O
N and OFF timers
at the same time.
●
To cancel either the ON or OFF timer, press
or
, then
press
.
CHECK
•
When there is error, the unit stops
its operation and tim
er indicator
blinks.
1.
Press for 5 seconds.
2
.
Browse for respective error code,
where “beep”
sounds are heard.
3. Turn off the power supply and call
authorized distributor.
Note:
Press the ‘Reset’ button to quit
checking.
Unit might operate with limited function
depending on error found
.
(Operation sta
rts, 4 “beep” sound is
heard)