What does H14 mean on my Panasonic CU-E18NKUA?
The H14 error in your Panasonic Air Conditioner indicates an abnormality with the indoor intake air temperature sensor. Possible causes are a faulty connector connection, a faulty sensor, or a faulty PCB.
Why is my Panasonic CU-E18NKUA Air Conditioner showing F97 (Compressor Overheating)?
The F97 error on your Panasonic Air Conditioner indicates compressor overheating, which may be due to refrigerant shortage (refrigerant leakage), a closed 2/3 way valve, or a faulty compressor tank temperature sensor.
What causes the F98 error on a Panasonic CU-E18NKUA Air Conditioner?
The F98 error in your Panasonic Air Conditioner indicates an input over current detection. This can be caused by compressor failure, a defective outdoor unit PCB, a defective inverter main circuit electrolytic capacitor, or excessive refrigerant.
What does H99 error mean on my Panasonic CU-E18NKUA?
The H99 error in your Panasonic Air Conditioner indicates indoor freeze prevention protection during cooling or soft dry modes. This can be due to a clogged air filter, dust accumulation on the indoor unit heat exchanger, an air short circuit, a faulty indoor pipe temperature sensor, or a faulty indoor unit PCB.
What does F95 error mean on a Panasonic Air Conditioner?
The F95 error in your Panasonic Air Conditioner indicates a cooling high pressure abnormality. This could be due to a rise in outdoor pipe temperature caused by a short circuit of hot discharge air flow, a defective outdoor fan motor, a defective outdoor pipe temperature sensor, or a defective outdoor unit PCB.
What does H98 error mean on my Panasonic Air Conditioner?
The H98 error in your Panasonic Air Conditioner indicates indoor high pressure protection. This can be caused by a clogged air filter, dust accumulation on the indoor unit heat exchanger, an air short circuit, a faulty indoor pipe temperature sensor, or a faulty indoor unit PCB.
What does H28 error mean on my Panasonic Air Conditioner?
The H28 error in your Panasonic Air Conditioner indicates an abnormality with the outdoor pipe temperature sensor. This can be caused by a faulty connector connection, a faulty sensor, or a faulty PCB.
What does H30 error mean on my Panasonic CU-E18NKUA Air Conditioner?
The H30 error in your Panasonic Air Conditioner indicates an abnormality with the compressor discharge temperature sensor. This could be due to a faulty connector connection, a faulty sensor, or a faulty PCB.
What does error code F11 mean on my Panasonic CU-E18NKUA?
The F11 error in your Panasonic Air Conditioner indicates an abnormality with the indoor pipe temperature sensor. This could be due to a faulty connector connection, a faulty indoor pipe temperature sensor, or a faulty indoor main PCB.
What does F96 (IPM Overheating) mean on my Panasonic Air Conditioner?
The error F96 in your Panasonic Air Conditioner indicates IPM overheating, which can be caused by a short circuit of hot discharge air flow, a defective outdoor fan motor, a defect in the internal circuitry of the IPM, or a defective IPM temperature sensor.
General| Cooling Capacity | 18, 000 BTU/h |
|---|---|
| Power Supply | 220-240V, 50Hz |
| COP (Coefficient of Performance) | 3.6 |
| Type | Split System |
| Refrigerant | R410A |
To Next Page
