113
Figure 8
Figure 9
Figure 10
15. Remove the screw from the
evaporator.
16. Remove the bearing by pulling it
out gently.
19. Fan motor can be removed after the
removal of cross flow fan.
18. Remove the cross flow fan from the unit by
pulling it to the left and downward.
17. Push the holdfast to the left and lift up the evaporator.
Cross flow fan
Evaporator
Reminder: To reinstall the fan motor, adjus
the fan motor connector to 45° towards you
before fixing control board.
Reminder: To reinstall the cross flow
fan, ensure cross flow fan is in line as
showninfigure10
Cross Flow Fan
To Next Page
Loading...
