To Next PageTo Next PageHow to retrieve error codes using Panasonic CZ-RL511D Remote Control?
To retrieve the error code using the Panasonic Remote Control: 1. Press the designated button for 2 seconds until you hear a beep. 2. Write down the error code. 3. Press the button for 5 seconds. 4. Turn the unit off to quit checking the error code, then reveal the error code to an authorized dealer.
What to do if Panasonic unit does not receive signal from the remote control?
If the unit isn't receiving the signal from the Panasonic Remote Control, make sure that the receiver is not obstructed and be aware that certain fluorescent lights may interfere with signal transmission. Please consult authorized dealer.
General| Type | Remote Control |
|---|---|
| Brand | Panasonic |
| Model | CZ-RL511D |
| Category | Remote Control |
| Power Source | Battery |
| Battery Type | AAA |
| Number of Batteries | 2 |
| Infrared | Yes |
Step-by-step guide to install batteries into the remote control.
Instructions for setting the current time on the remote control.
Overview of starting, stopping, mode selection, and temperature adjustment.
How to manually adjust fan speed or use AUTO mode.
Using the POWERFUL mode for rapid temperature adjustment.
Using the QUIET mode to reduce airflow noise.
Instructions for setting ON/OFF timers for the air conditioner.
Explanation of different operating modes like AUTO, HEAT, COOL, and DRY.
Recommended temperature ranges for energy efficiency.
Functionality of automatic restart after power failure.
Checks for remote control not working or signal reception problems.
Procedure to check and retrieve error codes from the unit.
Guidelines on proper disposal of electronic waste and batteries.
