4
1
2
3
4 5 6
No. Item Description
1 Power LED Indicates that the adaptor is being supplied
with power.
2 Status LED Indicates the status of the adaptor.
3 Link LED Indicates the communication status of the
adaptor.
4 WPS switch Switches WPS ON.
5 Register/Reset switch Enables user registration and resetting.
6 Check switch Check the communication status of the
adaptor.
Switches between Ethernet and Wireless
modes each time it is pressed and held for
10 seconds.
You can establish a connection with the internet with either the Ethernet
mode (wired) or the Wireless mode (wireless).
1
The Power LED lights.
2
The colour of the Status LED indicates the connection mode�
Power LED
Status LED
The colour of the Status LED changes each time the Check
switch is pressed and held for 10 seconds.
When connecting using the Ethernet mode (wired)
1
Ethernet mode is on�
If the Ethernet mode is not on, press and hold the Check switch for
10 seconds to switch to the Ethernet mode.
2
The Link LED lights to indicate that the connection has been established.
Use a shielded LAN cable.
When connecting using the Wireless mode (wireless)
1 Check the Status LED is blue to
on�
If the Wireless mode is not on, press and
hold the Check switch for 10 seconds to
switch to the Wireless mode.
2
3
The Status LED and Link LED light when communication is established.
* Refer to Troubleshooting (P.7), “When you cannot connect in the
Wireless mode” or “When you cannot connect in the Ethernet mode” when
you cannot connect to the network.
WPS switch
To Next Page
Loading...
