13. For DH-3ND1:
e-Hybrid Setting
(1) e-Hybrid will start to operate when e-Hybrid Button is pressed.
(2) By subsequently pressing the e-Hybrid Button, the shower condition will vary (refer to the figure below).
Note:
e-Cycle and e-Hybrid can be operated simultaneously.
14. Time Setting:
(1) Press "Set" Button.
Clock at LCD Display will blink.
(2) Press "+" to advance
(3) Press "-" to reverse
(4) Each press on "+" or "-" will add or minus 1 minute.
(5) Continuous press will add or minus 10 minutes.
(6) Press "Set" Button to confirm new time setting.(Blinking will stop)
Note:
When “Set” Button is not being pressed after time adjustment is completed, the clock will commence automatically 1 minute
later with the new clock setting with an additional of 1 minute.
Normal Shower
(If BUBBLE or BEAT
indicator turn off)
BUBBLE Shower
(continuous air)
(i)
(ii)
Safe
Safe
Bubble
BUBBLE Shower
with BEAT 3
(intermittent air)
(v)
Safe
Bubble
Beat
Level
PM
PM
PM
Set
+-
Set
+-
Set
+-
Set
+-
c) Pressing the "Set" Button again to confirm new cool temperature.
Note: For DH-3ND1, e-Cycle and e-Hybrid can be operated simultaneously.
• When “Set” Button is not being pressed after cool temperature adjustment is completed, the cool temperature will be
set automatically with an additional of 1 minute.
• If the inlet water temperature is higher than the cool temperature setting [ ], [ ] & [ ], the cool temperature
will be same as inlet water temperature.
• Cool temperature at
Power Off condition
(same as inlet water
temperature)
• Cool temperature is
approx. 8 °C lower than
hot shower temperature.
• Cool temperature is
approx. 10 °C lower than
hot shower temperature.
• Cool temperature is
approx. 5 °C lower than
hot shower temperature.
(i)
(iii)
(ii)
(iv)
Health Safe
Cool
PM
Health Safe
Cool
PM
Health Safe
Cool
PM
Health Safe
Cool
PM
Set
+-
BUBBLE Shower
with BEAT 1
(intermittent air)
(iii)
Safe
Bubble
Beat
Level
BUBBLE Shower
with BEAT 2
(intermittent air)
(iv)
Safe
Bubble
Beat
Level
- 28 -
To Next Page
Loading...
