You can control any two Panasonic
Palmcorders with one Remote control
(Optional, page 49). In order for the remote
to distinguish between the two units, it is
necessary to set one of the Palmcorders to
VCR 2. On the remote, press VCR 1 or
VCR 2 to control the desired Palmcorder.
For VCR 2: _=:
Press these
buttons at the
same time.
o,=o/ i
g LoL__J
For VCR 1:
"Press these
"11"
buttons at the
same time.
• When the Palmcorder and remote are
not set to the same mode (VCR1 or
VCR2), "CHECK REMOTE MODE
(REMOTE)" will appear.
REMOTE
A
Set the POWER to VCR or CAMERA.
o The POWER Lamp lights red.
• Be sure POWER is fully turned to
VCR or CAMERA position.
Press MENU to display the VCR or
CAMERA mode menu screen.
O
26
5
Rotate JOG KEY to select
k'-P4"-tl]_in the CAMERA mode menu
screen or_ in lhe
VCR mode menu screen, then press
JOG KEY to display the CAMERA
SET-UP or VCR PLAY MODE menu
screen.
Rotate JOG KEY to selectS,
and then press JOG KEY to select
VCR 2. (See pages 16_ 17.) Leave the
other Palmcorder set to VCR1.
Set the Remote Control (Optional,
page 49) to VCR 1 or VCR 2 to
correspond with the Palmcorder you
wish to control. (See above left.)
• After replacing the Remote Control
Battery, the remote wilf default to VCR 1.
Insert a slender pointed object, such as the tip of a ball-
point pen into the slot so that it fits into the hole (as shown
A). Then, while sliding to the right, pull the Battery Tray out
with your fingernail.
Insert the battery into the Battery Tray with the (_ mark
facing down.
Do not reverse the polarity.
Insert the Battery Tray.
i
Replacebattery withPanasonic PART NO.VSBW0004 (CR2025) !
only. Use ofanother battery may present a risk ol tire or explosion. |
Caution: battery mayexplode ilmistreated. Disposeof usedbattery |
properly, Keep awayfromchildren. Donot recharge,disassemble |
ordispose of in fire. J
To Next Page
Loading...
