-Before you begin
• Connect both Paimcorders to their |
power sources.
• Connect the two Palmcorders using th
DV interlace cable (LLINK)
(4-pin to 4-pin).
• Turn both Palmcorders ON.
High quality digital4o-digital copying can
be accomplished if both Palmcorders
incorporate the DV Input!Output (i.LINK)
Connector (DV interface cable (LLINK) is
not supplied).
Source (Playing)
Palmcorder
DV Input/Output
.LINK) Connector
Recording
Palmcorder
I
DV Interface Cable (i.LINK)
(O t onal) 3, 4, 5
6STOP 3, 4 PAUSE
Butt_ tt°n
4 RECSutton
_ 4REC
Button
-3, 4
PLAY Button
3,4,5
PAUSE
Button
44
1
2
Insert a pre-recorded tape into the
source (playing) Palmcorder, and set
POWER to VCR.
Insert a blank tape with the record
tab closed into the target (recording)
Palmcorder and set POWER to VCR.
4
5
Press PLAY on the source
Palmcorder. When the tape reaches
the point you want to starl dubbing,
press PAUSE.
Hold down REC and press PLAY on
the target (recording) Palmcorder or on
the remote control (optional, see
page 49).
Press PAUSE to pause the tape at the
starting point of the dub.
Simultaneously, press PAUSE on
both units to begin dubbing.
Press STOP on the recording
unit, and then press STOP on the
playing unit to end dubbing.
• When two Palmcorders are used for
dubbing, it is recommended thal the
remote control VCR1 or VCR2 setting be
used to avoid improver operation.
• When two Palmcorders are connected
using the DV interface cable (i.LINK) (not
supplied), a Video Editing Controller
cannot be used.
• Do not connect both an S-Video Cable or
A/V Cable and a DV Interface Cable
(i.LINK).
r CAUTION: ..................m
nauthorized exchanging andtor I
opying of copyrighted recordings may I
e copyright infringement, |
,,m ,,,H , r
To Next Page
Loading...
