EasyManua.ls Logo

Panasonic Digital Palmcorder PV-DV101 - Before Using; Cassette Insertion;Removal; Using the Light (Optional)

Panasonic Digital Palmcorder PV-DV101
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
if the Palmcorder is connected to a power
source, the cassette can be inserted and
ejected without turning the Palmcorder
on,
1TAPE EJECT
Before you begin ]
Connect the Palmcorder to a power
source. (See pages 11, 12.)
1
Slide TAPE EJECT to open the
Cassette Compartment Cover,
_,_ 2 insert a cassette record tab up,
3PUSHTO _% I_I window side facing out.
CLOSE mark_:..._-_--_ ! FI_ Press PUSH TO CLOSE mark to
close the Cassette Compartment
Cover.
To remove the cassette...
Slide TAPE EJECT to open the Cassette
Cassette Compartment Cover Compartment Cover and pull the cassette
tape straight out.
Hint to locate recording position when inserting cassette
When you insert a partially recorded cassette, use the Edit Search Function (see page
24) to visually confirm the point at which you want to start a new recording. EspecialLy
advisable when you want to add a recording to a tape that is already full
Note J
ll hand strap is tight it may prevent Cassette Compartmenl Cover from fully opening
for tape insertion or ejection. Loosen hand strap if necessary.
When inserting the cassette, make sure it faces in the right direction and then push in
completely. ...................
To brighten the natural colors in a scene.
Built-in Mount
Using the light will reduce battery
operating time.
Be sure to provide
adequate ventilation if using Light in a
hot environment for an extended period.
Be sure LIGHT is set to OFF when not in
use.
Do not attempt to lift or carry the
Palmcorder by holding the Enhancement
Light.
if _ight bulb needs to be replaced, take
Light to your nearest authorized
servicenter.
-Before you begin
"t
Connect the Palmcorder to a power |
source. (See pages tl, 12,)
J Set POWER to CAMERA.
Slide Light into the Built-in Light
Mount.
Be sure it locks into place.
Press LIGHTto turn 2LIGHT Button
ON or OFF. _=_
LIGHT RELEASE Button
To remove the Light:
PreSS LIGHT RELEASE and slide the Light
out of the mount.
Caution;
This light becomes hot during operation.
Make sure nothing covers the Light
during operation.
7

Related product manuals