[ Procedure of version-up for the Panasonic Digital Camera ]
This is the procedure to version-up the firmware into the latest version (Ver1.07) for DMC-FZ50.
1. Confirm the present firmware version
2. Download the firmware from HP
3. Copy the download file into the SD memory card
4. Write the firmware by the SD Memory Card
5. Confirm the newly written firmware version
< 1. Confirm the present firmware version >
The method of version confirmation for the firmware which is inside the camera is as follows.
1) Turn the "Power SW" off and connect AC Adapter and insert the battery and "SD card" which has recorded image data.
2) Set the mode dial into "Program AE" mode.
3) Turn the "Power SW" on pressing "OIS" and "Upper side cross key" simultaneously.
4) Set the mode dial into "Playback" mode.
5) After pressing "OIS" and "Downer side cross key" simultaneously, below message appears.
Remarks:
Beforehand, press "DISPLAY" button several times so that the indication on LCD monitor appears.
In case the setting condition is in Non-display mode, firmware version information does not appear.
6) After pressing "OIS" and "Downer side cross key" simultaneously again, firmware version display function is released automatically.
< 2. Download the firmware from HP >
1) Download the new firmware from AVCNBG CS-WEB Home Page
in your PC.
2) Expand the firmware, if the data is compressed.
< 3. Copy the download file into the SD memory card >
1) Copy the firmware "Ver 1.07" into the SD card using USB connected
connected DSC etc.
The name of firmware is "FZ50_107.bin". (extension name is "bin")
Remarks:
The location of the firmware in the SD card should be on the root position.
(Do not put the firmware in any folder. See right fig.)
2) After making the copy, disconnect the USB cable from DSC, if you utilize
DSC to make a copy.
Remarks:
Use SD card which has blank area more than 8MB.
In this case, it shows version "1.00"
Copy the firmware on
the root position.
1.00
To Next Page
Need help?
General
