Panasonic DMC-FZ70P - Lens Disassembly Procedure; Master Flange Unit Removal

29
8.4. Lens Disassembly Procedure
Precaution:
1. Do not remove the MOS when disassembling or re-
assembling the lens in order to maintain it clean.
When remove it, refer to item "8.5.".
2. Keep dust or dirt away from the lens.
3. Do not touch the lens surface.
4. Use lens cleaning KIT (BK)(VFK1900BK).
5. Apply grease as shown on item "8.4.6." and "8.4.7." in the
figure.
8.4.1. Removal of the Master Flange Unit
1. Remove the Dust-Proof Tape A and the Dust-Proof Tape
B.
2. Disconnect the connector (4 pin) of Focus Motor Flex.
3. Disconnect the connector (18 pin) of Shutter Flex.
4. Remove the Shutter Flex from the positioning boss.
5. Remove the 3 Screws (A) to remove the Master Flange
Unit.