Panasonic DMC-ZS25K - [Histogram]; [Video Rec Area]; [Zoom Resume]

VQT4P14
Basics
Using the [Setup] menu
- 48 -
• For the setting procedures of the menu. (→42)
[Histogram]
Displays distribution of brightness in picture – e.g.
if the graph peaks at the right, this means there are
several bright areas in the picture (Guide). A peak
in the center represents correct brightness (correct
exposure). This can be used as a reference for
exposure correction, etc.
(Example)
Dark ← OK → Bright
■
Settings: [ON] / [OFF]
●
When the histogram is not the same as that of the recorded picture under the
following conditions, histogram will be displayed in orange.
• When manual exposure assist indicates settings other than 0 EV in [Manual
Exposure] mode or during Exposure Compensation
• When the flash fires
• Dark locations
●
The histogram displayed during recording is only a reference.
●
The histogram displayed during recording and that displayed during playback may be
different.
●
The histogram is different from those displayed using the image editing software of a
computer.
●
The histogram will not be displayed in the following cases.
• [Intelligent Auto] Mode
• Playback Zoom
• During motion picture recording
• Multi Playback
• When the HDMI mini cable is connected
[Video Rec Area]
Enables verification of the recordable area for a motion picture before recording.
■
Settings: [ON] / [OFF]
●
Recordable area displayed for motion pictures should be interpreted as a Guideline.
●
When using Extended optical zoom, the recordable area may not always be displayed
for certain zoom ratios.
●
This setting is not displayed with [Intelligent Auto] Mode.
[Zoom Resume]
Remember the zoom position when turning the camera off.
■
Settings: [ON] / [OFF]