You can connect directly to a PictBridge-
compatible printer for printing.
Getting Ready:
• Charge the battery sufficiently. Or, connect
the AC adaptor (optional) and DC coupler
(optional).
• Insert card and set mode dial to any setting
except [_'. When copying pictures from the
built-in memory, remove any memory cards.
(Copy [CLIPBOARD] pictures to the card in
advance)
• Adjust the print quality or other settings on
your printer, as needed.
Turn on power of camera
and printer
_ Connect camera to printer
• Please make sure you use the
supplied USB connection cable. Use
of cables other than the supplied
USB connection cable may cause
malfunction.
Select [PictBridge (PTP)]
on the camera
• Do not disconnect the USB connection cable when
the cable disconnection icon _ is displayed (may
not be displayed with some printers),
Check socket direction and insert straight in.
(Damage to socket shape can lead to faulty
operation,)
Example of DMC-ZS7
USB connection cable
(always use cable supplied)
|To cancel print Press [MENU/SET]
When [CONNECTING TO PC...]
is displayed, cancel the connection
and set [USB MODE] (-*26) to either
[SELECT ON CONNECTION] or
[PictBridge (PTP)].
_ Press 41_ to select a
picture to print and press
[MENU/SET]
(Print settings (--_146))
® Do not use any other USB connection cables except the supplied one.
® Disconnect USB connection cable after printing.
_{Turn off power before inserting or removing memory cards.
®When the battery begins to run out during communication, a warning beep sounds.
Cancel printing and disconnect USB connection cable (recharge the battery before
reconnecting).
®Setting the [USB MODE] to [PictBridge (PTP)] removes the need to make the setting
each time the camera is connected to the printer.
®Motion pictures recorded in [AVCHD Lite] format cannot be printed.
144 VQT2R20
To Next Page
Loading...
