Panasonic DMP-BD85 - Recommended Audio Output Settings; Audio Settings Based on Connected Equipment

36
VQT2H83
The settings of the audio output vary depending on the connected equipment. Refer to the table below and set each of items.
Press [FUNCTION MENU] > select “To Others” > “[OK]”> select “Setup” > “[OK]”> “Sound” >
Set each item
For details of the each item, refer to page 29.
Recommended audio output setting
Example of connected equipment
TV via HDMI
*1
Receiver with
HD
audio
*2
decoder via
HDMI
Receiver without
HD
audio
*2
decoder via
HDMI
Receiver via
COAXIAL or
OPTICAL
Receiver
via analogue
output
*3
Setup menu
“Digital
Audio
Output”
“Dolby D/Dolby
D +/Dolby
TrueHD”
“PCM” “Bitstream
” “PCM” “PCM” No effect
“DTS/DTS-HD” “PCM” “Bitstream” “PCM” “PCM” No effect
“BD-Video
Secondary
Audio”
“Off” “Off” “Off” “Off” “Off”
“PCM Down Conversion” No effect No effect No effect
“Off
”
*4
No effect
“Downmix” “Stereo” No effect No effect “Stereo”
*5
No effect
“High Clarity Sound” “Enable”
“Disable
”
*6
“Disable”
*6
“Disable”
*6
“Disable”
*6
≥ Because underlined items are the factory presets, it is not necessary to change these settings.
*1
If connected to TV via except HDMI, these settings have no effect.
*2
HD audio: Dolby Digital Plus, Dolby TrueHD, DTS-HD High Resolution Audio and DTS-HD Master Audio
*3
Set “Analog Audio Output” to “7.1ch” or “2ch (Downmix) + 5.1ch”. (Press [FUNCTION MENU] > “To Others” > “Setup”)
*4
If the connected equipment that does not support 96 kHz, set to “On”.
*5
If the connected equipment that supports the virtual surround function, set to “Surround encoded”.
*6
When connected to TV via HDMI terminal for outputting image, set to “Enable”.
DMP-BD85GN&GA&GC-VQT2H83_eng.book 36 ページ ２０１０年２月５日 金曜日 午後１２時３９分