Getting started
VQT4W66
13
• While writing to/reading from the media, do not switch the
unit to standby mode or remove the media. Such action
may result in loss of the media contents.
• When inserting the media, ensure that it is facing the right
way up.
1 SD card slot indicator
2 Copying indicator
3 Disc indicator
4 Drive (HDD, BD or SD) indicator
5 Remote control signal indicator
6 Main display section indicator
- Current time
- Playback counter
- Various messages (> 104)
7 Playback indicator
8 USB port indicator
9 Timer recording indicator
• This indicator lights up when the timer
recording standby is activated.
Main unit
1 Standby/on switch (Í/I)
Press to switch the unit from on to standby
mode or vice versa. In standby mode, the unit
is still consuming a small amount of power.
2 Open/close disc tray
3 Blue LED
• It is possible to set the LED to turn on/off.
(> 85, Blue LED)
4 Disc tray
5 USB port
6 SD card slot
• When removing the SD card, press on the
centre of the card and pull it straight out.
Pull to flip down the front panel.
SD card
USB memory, etc.
Disc
7 Recording indicator
• The indicator will light up while recording.
• The indicator will blink while recording is
paused and before recording starts.
8 CALL LED
• The LED will light up when this unit receives
incoming call etc. of the video
communication. (> 68)
9 Remote control signal sensor
• Angle: Approx. 20° up and down, 30° left and
right
• Distance: Within approx. 7 m in front of the
unit
: Channel select (> 23)
; Start recording (> 27)
< Stop
= Start play
Display
PLAY
COPY
SD USB
HDDSD
BD
123
45
6789
DMRBWT835GL_eng.book 13 ページ ２０１３年２月１日 金曜日 午前９時５５分
To Next Page
Loading...
