20
RQT8388
STEP 3 Set up to match your television and remote control
Refer to the control reference on page 19.
You can configure the remote control TV operation buttons to turn
the television on/off, change the television input mode, select the
television channel and change the television volume.
1 Point the remote control at the television
While pressing [Í TV], enter the code
with the numbered buttons.
Manufacturer and Code No.
2 Test by turning on the television and
changing channels.
≥Repeat the procedure until you find the code that allows
correct operation.
≥If your television brand is not listed or if the code listed for
your television does not allow control of your television, this
remote control is not compatible with your television.
[Note]
≥If your television brand has more than one code listed, select the
one that allows correct operation.
Change the remote control code on the main unit and the remote
control (the two must match) if you place other Panasonic products
close together.
Use “DVD 1”, the factory set code, under normal circumstances.
1 While stopped
Press [FUNCTIONS].
2 Press [3, 4] to select “To Others”
and press [ENTER].
3 Press [3, 4] to select “Setup” and
press [ENTER].
4 Press [3, 4] to select “Others” and
press [1].
5 Press [3, 4] to select “Remote
Control” and press [ENTER].
6 Press [3, 4] to select the code (“DVD
1”, “DVD 2” or “DVD 3”) and press
[ENTER].
To change the code on the remote control
7 While pressing [ENTER], press and
hold the numbered button ([1], [2] or
[3]) for more than 2 seconds.
8 Press [ENTER].
∫ When the following indicator appears on the
unit’s display
The unit’s remote control code
Change the code on the remote control to match the main unit’s
(➡ step 7).
[Note]
Executing “Shipping Condition” in the Setup menu returns the main
unit code to “DVD 1”. Change the remote control code to 1
(➡ step 7).
To return to the previous screen
Press [RETURN].
To exit the screen
Press [RETURN] several times.
Television operation
e.g., 01: [0] ➡ [1] 10: [1] ➡ [0]
Brand Code
Panasonic/National 01, 02, 03, 04
GOLDSTAR/LG 15, 16
HITACHI 08
JVC 07
MITSUBISHI 09, 10
NEC 13
PHILIPS 12
SAMSUNG 12, 17, 18
SANYO 14, 19
SHARP 11
SONY 05
TOSHIBA 06
AUDIO
REC MODE
REC
CREATE
CHAPTER
ENTER
RETURN
SUB MENU
S
PAUSE
STOP
SLOW/SEARCH
SKIP
G-Code
CH
6
54
3
2
1
VOLUME
CH
AV
Í
TV
DRIVE
SELECT
Í
DVD
TIME SLIP
DISPLAY
MANUAL SKIP
ANALOGUE
PAG E
Turn TV on/off
Input select
Volume
Channel
Select
When other Panasonic products
respond to this remote control
Setup
Tun ing
Remote Control
Press “±” and “ENTER” together
for more than 2 seconds on the remote
control.
Disc
Picture
EH65.book Page 20 Friday, September 1, 2006 9:46 AM
To Next Page
Loading...
