Getting started
SQT1112
6
Main unit
• While writing to/reading from the media, do not switch the
unit to standby mode or remove the media. Such action
may result in loss of the media contents.
• When inserting the media, ensure that it is facing the right
way up.
• The USB port on the front side does not support
USB HDDs. Connect a USB HDD to the USB port on the
rear side. (> 57, Connecting the USB HDD)
Front
Pull to flip down
the front panel.
1 Disc tray
2 Display (> 7)
3 Remote control signal sensor
• Angle: Approx. 20° up and down, 30° left and
right
• Distance: Within approx. 7 m in front of the
unit
4 SD card slot
• When removing the SD card, press on the
centre of the card and pull it straight out.
5 Open/close disc tray
6 Standby/on switch (Í/I)
Press to switch the unit from on to standby
mode or vice versa. In standby mode, the unit
is still consuming a small amount of power.
7 USB port ( DC 5 V 500 mA)
Inserting or removing media
∫ Disc
∫ SD Card/USB device
DMRPWT560GN_eng.book 6 ページ ２０１６年４月１４日 木曜日 午後１時９分
To Next Page
Loading...
