Getting started
TQBS0033
6
Main unit
• While writing to/reading from the media, do not switch the
unit to standby mode or remove the media. Such action
may result in loss of the media contents.
• When inserting the media, ensure that it is facing the right
way up.
• When removing the SD card, press on the centre of the
card and pull it straight out.
• The USB port on the front side does not support
USB HDDs. Connect a USB HDD to the USB port on the
rear side. (> 46, Connecting the USB HDD)
Front
Pull to flip down
the front panel.
1 Disc tray
2 SD card slot
3 Display (> 7)
4 USB port ( DC 5 V 900 mA)
• This port supports USB 3.0 Super Speed.
5 Remote control signal sensor
• Angle: Approx. 20° up and down, 30° left and
right
• Distance: Within approx. 7 m in front of the
unit
6 CI slot (> 9)
7 Open/close disc tray
8 Standby/on switch (Í/I)
Press to switch the unit from on to standby
mode or vice versa. In standby mode, the unit
is still consuming a small amount of power.
Inserting or removing media
∫ Disc
∫ SD card/USB device
DMR-UBC&UBS90EG_eng.book 6 ページ ２０１８年５月２８日 月曜日 午後１２時５分
To Next Page
Loading...
