English
3
Charging
Charge
1. Set the switch
to “0•charge”,
and insert the
power cord into
the clipper.
2. Connect the AC
adaptor into an
outlet. The
charging
indicator lamp
will light up.
3. Disconnect the
AC adaptor
from an outlet
when charging
is completed.
The charging time is 12 hours.
1 full charge will provide approximately 60 minutes of continuous
operation.
Mounting and removal of the attachment
10/20/30/40mm comb attachment
1. Adjust the attachment to the desired
trimming height by sliding it until it
clicks while the switch is in “0•charge”.
Set the attachment to the correct position.
Otherwise you cannot set the switch to “1”.
Actual hair length will be a little longer than
the height you set.
•
•
•
•
►
Parts identification
A Main body
1 Attachment mounting
2 Switch
3 Charging indicator lamp
B Blade
4 Cleaning lever
5 Moving blade
6 Stationary blade
C 10/20/30/40mm comb
attachment
D Thinning (1/3) attachment
E 3/6mm comb attachment
F 9/12mm comb attachment
G AC adaptor (RE5‑79)
7 Power cord
8 Appliance plug
H Oil
I Cleaning brush
To Next Page
Loading...
