4
English
Cutting your hair
Cut
1
Cut hair to the correct height by
moving the clipper back against the
flow of the hair.
• Do not use the clipper in an inverted
position. This can cut hair too deeply.
Trimming with no attachments
Cutting without an attachment will trim hair length to 1 mm or less.
1. Cut hair by placing the clipper head
directly on the scalp.
AC operation
If you connect the AC adaptor to the clipper in the same way as for
charging, and set the switch to “1”, you can use it even if the
battery capacity is low.
If the clipper does not operate, set the switch to “0•charge”, wait
about 1 minute and then set it back to “1”.
Be careful not to discharge the battery completely with the switch
left in “1”. It results in shortening the battery life.
►
►
•
•
3/6mm, 9/12mm comb attachments
1. Select the
cutting heights
indicated on the
insides and
sides of the
attachments.
2. Mount the
attachment to
the clipper as
illustrated.
3. Remove the
attachment
from the clipper.
Thinning Attachment
1. Insert the attachment
over the trimming blades
until it clicks as
illustrated.
2. To remove the
attachment, push both
sides while pulling the
attachment.
►
►
To Next Page
Loading...
