English
5
Blade maintenance
Care
The following is the symbol for a washable clipper. The
symbol means the hand‑held part may be cleaned under
water.
Mounting and removal of the blade
1. Hold the clipper with the “Panasonic”
mark facing upward and push the blade
with your thumb while catching the
blade in your other hand.
Be sure to set the switch to “0•charge”
before you remove the blade.
•
2. To remount the blade, fit
the mounting hook into
the blade mounting on
the clipper and push in
until it clicks.
Blade life
Blade life will vary according to the frequency and length of use. It
is expected to be about 6 years when using the clipper twice a
month for 20 minutes each time. If cutting efficiency is reduced
despite proper maintenance, change the blades.
Battery life
Battery life will vary according to the frequency and length of use.
If the batteries are charged 6 times a month, the service life will be
►
►
approximately 3 years.
It is recommended that the clipper be recharged at least every 6
months even when not in regular use because the charge will
drain from the batteries and their service life may be shortened.
Cleaning the blade
If washing in water
Warning ‑ Detach the hand held part from the power cord before
cleaning it in water.
1. Rinse off any hairs
sticking to the blade and
any hairs inside the
clipper.
2. Shake the clipper 4 or 5
times gently, wipe off any
water drops from the
clipper and blade, and
then let it dry onto a towel
with the “Washable”
indicator facing upward.
•
►
To Next Page
Loading...
