7
English
How to use
• Clean the appliance after use.
1
2
Note
• The use time after a full charge is as follows.
ER‑CBL1: 50 minutes
ER‑CBN1: 40 minutes
(Based on dry using at 20 °C – 30 °C)
The operating time may differ depending on the frequency of
use and the operating method.
Even though the battery runs out, you can use for 5 minutes
after 3‑minute charge.
(This will differ depending on usage.)
Removing and mounting
• Make sure that the main body is turned off.
Remove the head while pushing the head release button (
a
Stand the head when it is removed.
Apply the whole system outer foil perpendicularly against the
skin and shave by slowly gliding the appliance over the face
against the grain of the beard.
• The beard under the chin and around the throat can be
shaved better by stretching the skin to raise the beard.
• To prevent damaging the system outer foil, do not shave with
only a part of the system outer foil.
Maintenance
• Make sure that the main body is turned off.
• Lubricate after cleaning and store the head with the
protective cap attached.
How to clean
With water
1
1)
2
3
4
2)
5
Be careful not to hit the appliance on the sink or any other
object while draining the water.
6
Allow the head to dry in the shade, avoid direct sunlight.
Do not dry the appliance with a dryer or a fan heater.
Notes
• Do not wipe with thinner, benzine, alcohol etc. Doing so may
cause malfunction, cracking or discoloring of the parts.
With the cleaning brush
1. Remove the outer foil section and the inner blades.
2. Brush off any hair trimmings from the head and the outer
foil section. (Fig. 5)
Clean the inner blades using the brush by moving it in
direction as illustrated.
Do not move the brush perpendicularly against the blades
as it will damage the inner blades and affect their sharpness.
To Next Page
Loading...
