Panasonic ER-GB96 - Cleaning

14
English
Cleaning
Clean the main body, blade and the attachment after each use.
(If not cleaned, the motion will become poor and the
sharpness will worsen.)
Turn the appliance off.
Remove the main body from the AC adaptor.
With water
To remove light dirt To remove heavy dirt
1. Remove the attachment
and turn the appliance
on.
2. Run water down the
water inlet at the front
of the main body,
rinse thoroughly for
approximately 20
seconds, and then turn
the appliance off.
1. Remove the attachment
and blade.
2. Clean the appliance, the
blade and the attachments
with running water.
Be careful not to hit the main body on the sink or any other
object while draining the water. Failure to do so may cause
malfunction.
Rinse with water and shake up and down several times to
remove the water.
Fullbeard
Holdingtheappliancewiththe
powerswitchatthebottom,and
keepingthebladeata90°angleto
the direction of the hairs, trim and
shapeyourbeardasdesired.
Ends of moustache
Holdingtheappliancewiththe
power switch facing outside,
trimgraduallyfromtheendsby
bringingthebladeincontactwith
theskin.
ER-GB96_86.indb 14 17/12/13 下午2:31