Lubrication
• Apply the oil to the blade before and after each use.
1
Remove the blade�
(See this page�)
2
Apply a drop of the oil to each
indicated point�
3
Attach the blade to the main
body, turn on the power and
allow to run for
approximately 5 seconds�
Removing and mounting the blade
► Removing the blade
Hold the main body with the switch
facing upward and push the blade with
your thumb while catching the blade in
your other hand.
► Mounting the blade
Fit the mounting hook (B) into the blade mounting (A) on the
main body and then push in until you hear a click.
ER-SB40_CAN.indb 14 2017/07/18 18:04:16
To Next Page
Loading...
