This Beard/Hair Trimmer is for the
trimming and care of mustaches,
beards and hair. Trimming length can
be adjusted between 1 to 20 mm. The
trimmer can be operated either from
an AC power source or on its own
rechargeable battery.
Parts identification
(see fig. 1)
Before use
A Switch
Slide up to turn on, slide down to
turn off.
B Charge Indicator Lamp
Lights when the unit is connected
with the adaptor M to an AC
power source for charging.
C Main Blade
A precision 39 mm-wide blade
which can be used with the comb
attachment F.
D
E Trimming Length Indicator
Indicator Trimming Length
1 1.0 mm (1/32˝)
2 2.0 mm (5/64˝)
• 3.5 mm (5/32˝)
5 5.0 mm (3/16˝)
• 6.5 mm (9/32˝)
8 8.0 mm (5/16˝)
• 9.5 mm (3/8˝)
11 11.0 mm (13/32˝)
• 12.5 mm (1/2˝)
14 14.0 mm (17/32˝)
• 15.5 mm (5/8˝)
17 17.0 mm (21/32˝)
• 18.5 mm (23/32˝)
20 20.0 mm (25/32˝)
• The actual hair length may be
longer than the set trimming hight.
F Comb Attachment for Hair
Use this to control the trimming
length. (see fig. 3)
G Moving Blade
H Stationary Blade
I Cleaning Lever
Push this lever to remove bits of
hair caught between the station-
ary blade and the moving blade.
Quick Adjust Dial
Turn the dial to a higher setting to
raise or lower the comb attach-
ment F to the desired length
(between 1 and 20 mm) (see fig.
2). The comb attachment is locked
in position when the switch is set
to “1”.
J Blade Block
Release to remove the blade
block from the housing to clean
or replace the blade. (see fig. 12)
To Next Page
Loading...
