Panasonic ER389X - Lubrication; AC Adaptor Cleaning; Troubleshooting

13
English
Lubrication
• Apply the oil to the trimmer before and after each use.
Apply a drop of the oil to each
indicated point.
Failure to apply the oil may cause
the following problems due to
rust, wear or burn out.
-The clipper has become blunt.
-Shorter operating time.
-Louder sound.
Cleaning the AC adaptor
Use a brush to clean hair trimmings and dust in the charging plug or in
the hole on the bottom surface.
Troubleshooting
Problem Action
The trimmer has become
blunt.
Charge the trimmer.
(See page 11.)
Clean the blade and apply oil.
(See pages 12 and 13.)
Replace the blade.
(See page 12.)
Trimmer stopped functioning.
Operating time is short even
after charging.
Charge the battery for
approximately 16 hours
continuously to rejuvenate it.
If few uses remain even after
charging, the battery has reached
the end of its life. (Fluid may be
leaking due to degradation at the
end of battery life.)