Panasonic ES-LT2B - Troubleshooting: Foam, Charging, and Battery; Foam and Shaving Sensor Issues; Charging and Battery Life Problems

20
English
Problem Action
The shaving sensor
responds even though
the shaver is not in
contact with the skin.
Clean the beard trimmings
from the shaver.
When the shaver is very dirty,
rstusethecleaningbrushto
remove beard trimmings.
Or, remove the foil frame
and wash with water.
(See page 16.)
Replace the system outer
foil and/or inner blades.
Expected life of system
outer foil and inner blades:
System outer foil:
Approximately 1 year
Inner blades:
Approximately 2 years
Foam cannot be made
in shaving foam mode.
Making foam may be
di󰀩cultdependingonthe
type of facial cleansers etc.,
so adjust the amount of
water or facial cleanser.
Foam made in
shaving foam mode
contains shavings.
Before making foam, cleanly
rinseo󰀨anyshavings.(See
page 15.)
Problem Action
The shaver cannot be
charged.
The recommended
temperature for charging is
10 °C – 35 °C. If charged at
a temperature other than
the recommended
temperature, the shaver
may take longer to charge
or may not charge at all.
Operating time is short
even after a full charge.
The shaver can be used for
about 2 weeks on a full
charge assuming dry‑
shaving for 3 minutes per
day. However, the usable
number of days may be
reduced depending on how
the shaver is used (for
example, use in shaving
foam mode, wet shaving, or
use in low temperatures).
Apply oil.
When the number of
operations per charge starts
to decrease, the battery is
nearing the end of its life.