Panasonic ES-LV95 - Cleaning Modes and Procedures

18
►Cleaning the shaver
Remove any soap or water on the shaver if it has been
washed with hand soap or any other detergent.
1
1
Insert the appliance plug
[
C] into the self-cleaning
recharger [
B] .
2
2
Remove the protective cap
[ A1] and then attach the
shaver.
3
3
Plug in the adaptor [C]
into a household outlet.
1
2
3
• Turn the shaver off before attaching.
• Wipe off any water droplets on the main body rear terminals.
• Check that the outer foil is not deformed or damaged when
you are attaching the shaver.
4
4
Press the SELECT button [B] to select the
mode.
• The “Charge” mode starts when attaching the shaver.
• Each time you press the SELECT button, the mode changes
from “Clean/Dry/Charge”
“Dry/Charge” “Charge”.
• The modes start approximately 6 seconds after they are
selected.
• The mode will be aborted if the power is cut off. In this case,
perform the mode again from the beginning.
• Do not press the cleaning liquid unit removal button as the
cleaning liquid may spill causing a malfunction.
Mode Time required (guide)
1 Charge
Charge
0 to 60 min
2 Clean/Dry/
Charge
Clean
10 min
Dry
80 min
(170 min*)
Charge
0 to 60 min
• It is not possible to change the mode after
the “Clean/Dry/Charge” mode has started.
3 Dry/
Charge
Dry
180 min
Charge
0 to 60 min
• It is possible to change to the “Clean/Dry/
Charge” mode even after the “Dry/Charge”
mode has started.
* When the ambient temperature of the self‑cleaning recharger
is low (approx. 15 °C or lower), the time it takes to dry the
shaver increases.
• Use the self‑cleaning recharger in temperatures between
15 °C and 35 °C.
• The Clean or Dry function may stop under extreme low
temperatures (approx. 0 °C or lower). In such a case, the
STATUS lamp will glow for approximately 5 seconds and the
mode will switch to the “Charge” mode without allowing you
to select the “Clean/Dry/Charge” mode or the “Dry/Charge”
mode.
ES-LV95_EU.indb 18 2013/07/04 18:43:13