18
English
2
Press for more than
2 seconds to activate the
sonic vibration cleaning
mode�
• Splashing of foam is suppressed.
• The battery capacity lamps blink
in order.
• After about 20 seconds, it will be automatically
turned off, or you can turn it off by pressing the
power switch.
3
Remove the outer foil
section and clean with
running water�
• See page 19 for removing the
outer foil section.
• Splashing is reduced by rinsing the shaver in sonic
vibration cleaning mode.
• After rinsing with water, shake the shaver up and
down for a few times to remove excess moisture and
then wipe off any drops of water with a dry cloth.
4
Attach the outer foil
section and dry with the
self-cleaning recharger�
1. Insert the shaver into the
self‑cleaning recharger and
plug the adaptor into a
household outlet.
• Check that the charge status
lamp (
) is glowing.
2. Press
twice.
2
1
The DRY lamp glows, and the “Dry/Charge”
mode will start after approximately 6 seconds.
• It is possible to change to the “AUTO” mode
even after the “Dry/Charge” mode has started.
Dry
180 min
Charge
0 to 60 min
3. Remove the adaptor after the selected mode is
completed.
5
Lubricate the shaver�
It will keep the movement of the
blades smooth and maintain a
comfort shave.
1. Apply one drop of oil to each of
the system outer foils.
2. Raise the trimmer and apply a drop of oil.
3. Switch the shaver on, and run it for approximately
ve seconds.
4. Switch off the shaver, and wipe off any excess oil
from the system outer foil with a soft cloth.
►Drying the shaver without the self-cleaning recharger
Dry in a shade and apply oil.
To Next Page
Loading...
