18
English
Problem Action
The power will not
switch to OFF.
Press the power switch
twice while using in shaving
foam mode.
The shaving sensor
does not respond.
The shaving sensor may not
respond when the remaining
battery capacity is low. If this
happens, recharge the shaver.
Apply oil. (See page 16.)
The shaving sensor may not
respond when there is not
enough oil on the blades.
Depending on the beard
thickness or the amount of
beard trimmings in the shaver
head, the shaving sensor
may not react and the driving
sound may not change. This
is not abnormal.
The shaving sensor may not
respond depending on the type
and quantity of the shaving gel.
This is not abnormal.
Problem Action
The shaving sensor
responds even
though the shaver is
not in contact with
the skin.
Clean the beard trimmings
from the shaver.
Clean the system outer foil with
the brush. (See page 16.)
When the shaver is extremely
dirty, remove the foil frame
and wash with water.
(See page 15.)
Replace the system outer
foil and/or inner blades.
Foam cannot be
made in shaving
foam mode.
depending on the type of
facial cleansers etc., so
adjust the amount of water
or facial cleanser.
Foam made in
shaving foam mode
contains shavings.
Before making foam, cleanly
page 15.)
To Next Page