19
RO H SK CZ PL FIN S N P DK E NL I F D GB
Cleaning the self-cleaning recharger
Beard trimmings may become attached to the cleaning tray of
the self‑cleaning recharger. Follow the steps below to remove
them. We recommend doing this each time you change the
cleaning liquid.
1. Be sure to remove the cleaning liquid
unit [B] and the appliance plug [CN]
from the self‑cleaning recharger [B].
• Be careful not to spill the cleaning liquid.
• Some cleaning liquid components and
skin oil may separate and adhere to the
cleaning liquid unit and cleaning liquid
filter. This does not indicate a problem.
2.
Pour water as illustrated
while tilting the cleaning liquid
unit and shaking it gently.
• You can clean with the
cleaning liquid filter removed.
• After washing, be sure to
attach the cleaning liquid
filter.
3. Gently wipe off any beard trimmings
attached to the inside of the cleaning tray
with a cloth or tissue paper dampened
with water.
• Clean the corners and uneven parts of
the cleaning tray with a cotton swab
dampened with water.
►When the water does not drain from the cleaning tray
• Do not tilt the self‑cleaning recharger to pour out water. Doing
so may cause the cleaning liquid in the cleaning liquid unit to
spill or cause the self‑cleaning recharger to malfunction.
Beard trimmings may clog the drain at the
bottom of the cleaning tray.
In this case, you cannot clean or dry the shaver.
Push the beard trimmings down through the
drain with a toothpick etc.
To Next Page
Loading...
