20
Troubleshooting
►Self-cleaning recharger
Problem Action
The blade has not been
thoroughly washed.
If the shaver is not cleaned for
more than 2 weeks, first clean
with the cleaning brush to remove
beard trimmings. (See page 18.)
Do not add detergent and water
except when replacing the
cleaning liquid.
Doing so may deteriorate the
cleaning function. (See page 16.)
After cleaning, oil‑like droplets
may remain on the outside of
the foil frame. This is the
lubricating component of the
cleaning liquid and does not
indicate a problem. You may
wipe it off with a soft cloth.
The STATUS lamp glows.
See page 22.
Problem Action
The mode does not start.
Check that the AC adaptor is
connected to the self‑cleaning
recharger, and that the AC
adaptor is plugged in to a
household outlet. (See page 12.)
Confirm that the shaver is
properly attached to the self‑
cleaning recharger.
(See page 12.)
The Clean or Dry function may
stop out of recommended
ambient temperature range.
(5 – 35 °C)
Check if the STATUS lamp
glows. (See page 22.)
Cleaning liquid has
accumulated in the
cleaning tray.
Remove any waste, etc. that
has accumulated in the drain at
the bottom of the cleaning tray.
(See page 19.)
If you use the self‑cleaning
recharger when the shaver is
wet or when soap or shaving
gel is on the shaver, cleaning
liquid may accumulate in the
cleaning tray.
To Next Page
Loading...
