Panasonic ES7109 - Page 7

7
Cleaning the shaver
1
2
3
4
5
select
status
charge
dry
clean
1
1
Insert the appliance
plug.
2
2
Plug in the adaptor.
Remove any soap or water on
the shaver if it has been
washed with hand soap or
any other detergent.
•
3
3
Pull up the arm.
4
4
Remove the protective
cap and then attach the
shaver.
Turn the shaver off before attaching.
Check that the outer foil is not
deformed or damaged when you are
attaching the shaver.
5
5
Push down the arm.
•
•
6
6
Press [select] to select the course.
Each time you press [select], the course changes from
“Clean/Dry/Charge”“Clean/Dry”“Dry/Charge”
“Dry”“Charge”.
The courses start approximately 6 seconds after they are
selected.
The course will be aborted if the power is cut off. In this
case, perform the course again from the beginning.
Do not detach the detergent cartridge or the water tank as
the cleaning liquid may spill causing a malfunction.
•
•
•
•
Course
Course selection indications
On shaver

Course completion summary
On recharger
Changeable course
halfway through
On recharger On shaver
Time required
(guide)
clean dry charge
clean dry charge
Charge
*

Glows

Blinks 1 hour
Clean/Dry/
Charge

Glows while
charging

Blinks 4 h 30 min
Clean/Dry

–

– 3 hours
Dry/Charge

Glows while
charging

Blinks 4 h 20 min
Dry

–

– 2 h 50 min
*The lamp goes out in 6 seconds.

(6B$86LQGE 