Panasonic ES8066 - Before Use; Parts Identification

Before use
This Wet/Dry shaver can be used for
wet shaving with shaving lather or for
dry shaving. You can use this water-
tight shaver in the shower and clean
it in water. Treat yourself to wet lather
shaves for at least three weeks and
notice the difference. Your Panasonic
Wet/Dry shaver requires a little time
to get used to because your skin and
beard need about a month to adjust
to any new shaving method.
Charge the shaver for at least 15
hours before using it for the first time
or when it has not been in use for
more than six months.
Parts identification
(see fig. 1}
Protective cap
System outer foil
System outer foil release buttons
Foil frame
inner blades
Foil frame release buttons
On/Off switch
Switch lock button
Recharge lamp
Charge status lamp
Trimmer
Trimmer handle
Charging adaptor with auto-
matic voltage adjustment
Wall mount
Wood screws
Travel pouch
BOS SBOGOO0GODHOOO®
How to use the wall mount
DANGER- To reduce risk of death by
electric shock, do not install where
unit can fall into a tub or sink.
The charging adaptor can be hung
on the wall using wood screws (in-
cluded).
1. Select an appropriate location on
the wall where the screws can go
in.
2. Attach the wall mount to the wall
as shown with the wood screws,
making sure that the arrow points
up.
3. Slide the charging adaptor
grooves into the wall mount until
it clicks in.
To remove the charging adaptor from
the wall mount, slide the adaptor up-
ward.
Charging
(see fig. 2)
Place the charging adaptor upright
on a flat surface or mountit on a wall.
Plug the adaptor into an AC outlet.
It will adjust automatically to voltages
between 100-120 and 220-240V AC.
In some areas, a special plug adap-
tor may be required.
Switch the shaver to the “O + charge”
position and place it upright into the
charging adaptor with the switch fac-
ing toward the front.
The charge status lamp will glow red
and it will stay on until the shaver is
removed from the adaptor (see fig. 2A).
You can fully charge the shaver in 12
hours if the recharge lamp flashes
red (see fig. 2B).