Panasonic ES8066 - Page 8

Replacing shaving head
components
It is recommended that you replace
the outer foil at least every year and
the inner blade at least every two
years to maintain your shaver's cut-
ting performance.
Replacing the system outer foil
{see fig. 7)
Squeeze the system outer foil re-
lease buttons and lift the system
outer foil upward to remove it. To in-
sert the new system outer foil, press
down until it snaps into place.
Replacing the inner blades
(see fig. 8)
Squeeze the foil frame release but-
tons and lift the foil frame upward to
remove it. Remove the inner blade
one at a time by grasping it firmly at
both ends and pulling straight away
from the shaver. To insert the new
inner blades, hold the blade one ata
time at both ends and press down-
ward until it snaps into place.
Caution
« Do not charge the shaver where the
temperature is below 0°C (32°F) or
above 40°C (104°F), where it will
be exposed to direct sunlight or a
heat source, or where there is a lot
of moisture.
e Use only the included shaver
charging adaptor RE3-78 to charge
the ES8065/ES8066 shaver.
« The supply cord of the charging
adaptor cannot be replaced; if the
cord is damaged, the entire charger
should be discarded.
* Dry the shaver completely before
setting it in the charging adaptor.
° Keep the charging adaptor away
from water and handle it only with
dry hands. Do not use an exten-
sion cord to connect the charging
adaptor to an outlet.
The shaver may not immediately
begin to charge after being placed
into the charging adaptor after use.
Allow the shaver to sit in the charg-
ing adaptor for a few minutes and
check again to make sure that it is
being charged.
Do not place any metal objects like
coins and paper clips on the charg-
ing adaptor as they will become
warm.
Grip the plug when disconnecting
the charging adaptor from a recep-
tacle; tugging on the cord may
damage it.
Store the charging adaptor and its
cord set in a dry area where it will
be protected from damage.
The linear motor of the shaver may
Start operating without the power
switch on if the shaver is placed
near a television, stereo, audio/
visual equipment or anything that
generates a strong magnetic field.
The outer foil is very thin. if han-
died improperly, it can be easily
damaged. To avoid personal injury,
do not use the shaver if it has a
damaged foil or inner blade.
Wash the shaver in tap water. Do
not use salt water or boiling water.
Also, do not use cleaning products
that are designed for toilets, bath-
rooms or kitchen appliances. Do