Charging
Charge
1
1
Insert the appliance plug
into the shaver.
2
2
Plug in the adaptor into a
household outlet.
The indicators on the LCD panel glow
and charging starts.
Charging is completed when the
indicators on the LCD panel blink.
(Max. 1 hour later)
•
•
Cord shaving
If you insert the appliance plug to the shaver and plug in the
adaptor into a household outlet, you can use it even if the battery
capacity is low.
If the shaver does not work, continue charging it for approx. 1
minute.
•
About the LCD panel
The LCD panel shows the remaining battery capacity from 0% to
100%, in 10% increments.
While charging
After charging is
completed
10 minutes after
charging is
completed
The indicators
glow.
The indicators
blink once every
second.
The indicators blink
once every 2
seconds.
During use After use
The used time is shown.
The shown time returns to
[0’00”] after 10 minutes.
•
The used time and the
remaining battery capacity
are shown alternately after
turning off the shaver.
When the battery capacity is low
You can shave 1 to 2 times after “10%” appears.
(This will differ depending on usage.)
•
“10%” appears and blinks.
A full charge will supply enough power for approx. 14 shaves of
3 minutes each.
•
To Next Page
Loading...
