Caution for turbo mode
Shaving in turbo mode may damage your skin. Turn the shaver
off and then on again to cancel turbo mode.
Do not place your fingers on the 0/1 switch while using the
shaver. This may cause the shaver to turn off or enter turbo
mode. Place your fingers on the finger rest while using the
shaver.
•
•
Lubrication
To maintain shaving comfort for a long time, it is recommended
that the oil provided with the shaver is used.
1. Switch off the shaver.
2. Apply one drop of oil to each of the outer foils.
3. Raise the trimmer and apply a drop of oil.
4. Switch the shaver on, and run it for approximately five
seconds.
5. Switch off the shaver, and wipe off any excess oil from the
outer foils with a soft cloth.
Replacing the system outer foil and the inner
blades
appears on the LCD panel once a year. (This will differ
depending on usage.) We recommend checking the system outer
foil and the inner blades when it appears.
Press the 0/1 switch for more than 30 seconds to delete .
system outer foil once every year
inner blade once every two years
1. Press the system outer foil
release buttons and lift the
system outer foil upwards as
illustrated.
2. Remove the inner blades one
at a time as illustrated.
Do not touch the edges
(metal parts) of the inner
blades to prevent injury to
your hand.
3. Insert the inner blades one at
a time until they click as
illustrated.
4. Insert the system outer foil by
pushing it downwards until it
clicks.
•
•
To Next Page
Loading...
