Panasonic ET-D75LE95

ENGLISH-9
Lens position setup
Automatically return the lens to standard position using the projector.
The menu screens shown in these operating instructions are only provided as examples. Actual menu screens
may vary with the specic model.
● When using PT-RZ31K / PT-RS30K / PT-RQ13K / PT-RZ12K / PT-RS11K / PT-DZ21K2 / PT-DS20K2 /
PT-DW17K2 / PT-DZ16K2
Lens position setup and focus adjustment
1) Turn on the projector, and start
projection.
2) Press the <DEF
AULT> button on
the remote control while the shift
adjustment screen is displayed.
z
The [HOME POSITION] screen is displayed.
3) Press
◀▶
to switch the item.
z
The items will switch each time you press the button.
[NORMAL]
Moves the lens to the home position.
Select this item when replacing or removing
the projection lens. Select this item
when the Fixed-focus Lens (Model No.:
ET-D75LE50) is used for projection.
[D75LE95]
or
[D75LE90]
*1
Moves the lens to the ET-D75LE95 lens
standard position.
Select this item when the Fixed-focus
Lens (Model No.: ET-D75LE95) is used for
projection.
*1: The items displayed will differ depending on the projector
model.
4) Press the <ENTER> button.
z
[PROGRESS] is displayed in the [HOME POSITION]
screen, and the lens position returns to the home
position or the lens standard position.
LENS
HOME POSITION
EXECUTE
CANCEL
ENTER
MENU
NORMAL
CHANGE
Note
z
Complete the operation within approximately 5 seconds after the [HOME POSITION] screen is displayed. The
[HOME POSITION] screen will disappear after time limit.
z
The home position of the lens is used when the lens is being replaced or when the projector is being stored,
and it is not the optical center of the screen.
z
You can also display the [HOME POSITION] screen by pressing the <LENS> button on the control panel or
the <SHIFT> button on the remote control for at least three seconds.