To Next PageTo Next PageWhat to do if my Panasonic Personal Care Product does not operate?
If your Panasonic Personal Care Product isn't working, first ensure the batteries are correctly inserted. If the issue persists, replace the old batteries with new ones.
Why is my Panasonic Personal Care Product leaking water from the bottom cover?
If you notice water leaking from the bottom cover of your Panasonic Personal Care Product, it's likely that the rubber ring isn't properly installed. Reinstall it, ensuring the convex part (m) faces outward.
What to do if no water comes out of my Panasonic Personal Care Product?
If no water comes out of your Panasonic Personal Care Product, it might just need some time to prime. Try putting water into the nozzle port (k), install the nozzle, and then turn the switch on.
Why is the water jet poor in my Panasonic Personal Care Product?
A poor water jet in your Panasonic Personal Care Product could be due to several reasons: * The nozzle might be clogged, in which case you should replace it. * The outlet of the nozzle may be squashed, also requiring a nozzle replacement. * The unit might be tilted too much; try using it upright.
How to fix a Panasonic Personal Care Product when the tank cap comes off?
If the tank cap of your Panasonic Personal Care Product comes off, align it with the axis and push it in.
General| Brand | Panasonic |
|---|---|
| Model | EW-DJ11 |
| Category | Personal Care Products |
| Language | English |
Explains hazard and instruction symbols for safe operation and injury prevention.
Instructions on directing the water jet between teeth for effective interdental cleaning.
Guidance on cleaning periodontal pockets by directing the water jet along the gums.
Addresses issues with a weak or poor water jet, including clogged filters or nozzles, and unit tilt.
Solutions for when no water comes out of the nozzle, such as filling the nozzle port or ensuring proper setup.
Troubleshoots water leaks from the bottom cover, often due to improper installation of the rubber ring.
Diagnoses why the appliance may not operate, including battery installation and battery charge status.
Provides a solution for the tank cap coming off, involving alignment with the axis and pushing it in.
